Skip to main content

Application example

Screw assembly of components

Header image

The challenge:

When screwing the outer casing of the cordless screwdriver together, several parameters must be observed – from the order of the screws to the different tightening torque for the individual screws. The varied positions at which the parts are fed complicates the process step even further.

Our solution:

For a reliable detection of the component position, the VISOR® Robotic vision sensor is mounted on a stationary arm, where it determines the location and orientation of each of the case halves and adjusts the screw insertion points accordingly.

The hardware of our vision sensors is optimally enhanced by the VISOR® software, which allows you to set up applications in a few simple steps and configure process parameters. The software also allows continual monitoring of the process. This same software also configures the whole range of VISOR® Code Reader, VISOR® Object, VISOR® Allround camera models. Reducing your training needs and software holding.

Your benefits:

  • Reduced programming due to the automatic calculation by VISOR® Robotic of robot’s 3D start position
  • Increased throughput, uptime and overall quality
  • Reduced mechanical complexity, therefore allowing flexible expansion of installation

Recommended products for this application: